Remove hub bolt 23mm I think.
Remove lower ball joint 14 XZN (spline) needed
Pull hub away from shaft
Drive the hub bolt back into the hub
CV will pop of the shaft, cut boot clips
Remove joint and note position of seals and clips and remove boot
Clean the shaft and apply thin layer of new grease to splines
Instal small boot clip and boot slide them up the shaft and fit CV seals and clip and some grease
Pack the grease well into the new CV and work it into the bearings
Press the joint onto the shaft and tap it home
Fit the boot and crimp the boot clips.
Now put it all back together, you may or maynot need to remove the bottom bolt from the shock absorber to aid setting everything back up. Make sure everything is well tight and your sorted.