VW T4 Forum - VW T5 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Interior
    Does anyone have the part number or can advise where to buy the black plastic cap that sits over the lower seatbelt bolt on rear seats of kombi? I'm missing one, the one still in place is kind of an offset shape deliberately designed to hit the bodywork which prevents the lower anchor point from...
  2. Engine & Gearbox
    Hi, I'm in the midst of a tdi conversion and am also doing the 5th gear swap, whilst getting the small driven gear off (one hell of a task as it was stuck solid) the thread on the bolt that holds it got rolled so I need a new bolt before I can replace the gear. I noticed the bolt that came...
  3. Engine & Gearbox
    For the second time this year, the bolt holding the alternator in place on my 2001 1.9TD has snapped, this is also the third alternator this year. The first alternator failed at teh sme time as the first bolt snapping (not sure what came first), teh second alternator failed but the bolt was...
  4. Interior
    Hi all, Does anyone know for sure the thread size of the (6) bolts used at the lashing/tie-down/D-ring points in rear of van.. I'm guessing they are M10? correct or not? Is it standard metric thread or some weird VAG thread? Thanks
  5. General T4 Chat
    88 2.5 t4 Asked that the water pump and all 'belts" be replaced plus all relevant bits. Replaced all belts, tensioners and water pump but not the Crank pulley stretch bolt. Am I right in thinking it is a must to replace? Where can I find documentation to show the maccy? Cheers::*
  6. Engine & Gearbox
    Hello All, I need to change the stub shaft on my T5 2007 1.9. Problem is the 6mm allen bolt holding it in has been rounded slightly by whoever put it in previously. So when i try putting any pressure on the allen key it just wants to turn and round the head of the bolt even more. Anybody got...
  7. General T4 Chat
    So today I picked up my T4 from a reputable independant garage in Bristol. The N/S/F ball joint and bushes needed replacing and I asked them to fit a pair of sidebars as well. After paying and driving to Zmoks to get some electrics looked at (about 5 miles)we noticed that the side bar didn't...
  8. Engine & Gearbox
    So, a few weeks ago, the Top O/S engine mount sheared it's top 2 bolts into the block. Tried my luck with a 90 degree drill which was hopeless, so it was decided that I'd drop the box and motor, and do the job properly... Sheared bolts looked like this: They were impossible to get to due to...
  9. Brakes
    Just been out to change the rear pads on my 1.9td, as i noticed that the rear drivers disk has not been working properly as i could see rust marks that were staying when all other disks were being rubbed clean with use. i managed to get the old pads out and just about got the new ones in place...
  10. Wanted
    As title, any condition. As cheap as possible, or check out my eBay link incase there's something you'd swap for? http://www.ebay.co.uk/sch/thedibb/m....id=p4340.l2562 Closer to Conrwall the better :D
1-10 of 10 Results