Hi all, i have a confirmed leaky slave cylinder, as it's a 2003 t4 102bhp acv engined caravelle it has the slave cylinder in the gearbox so might as well suck up the cost and have the lot done in one go…anyone got a ballpark figure and a recommendation for a local specialist to replace the dmf...

Hi all, i have a puddle of fluid on the floor and classic slave cylinder failure symptoms….( the master cylinder was replaced along with pedal box before i bought it and that looks all nicely aligned and is bone dry i have had 3 failures of these on previous t4 so i'm deffo not losing fluid...

Hey guys, total noob here I know. I am trying to see if there is anything wrong with my slave cylinder. I have removed it today. But my question is. Should the green rubber boot be external or internal inside the cylinder? What is the rubber boots purpose!? It's from a vw t4 1996 (2litre...

Hey guys, total noob here I know. I am trying to see if there is anything wrong with my slave cylinder. I have removed it today. But my question is. Should the green rubber be external or internal inside the cylinder? It's from a vw t4 1996 (2litre petrol I think) Looking online there are...

Hi all. I have a new ( to me ) 97 2.5L Petrol T4 down here in Australia. I have a gear engagment issues where sometimes the clutch will not engage. Have bleed several times and toped up brake fluid. I have decided to change the Master and Slave cylinder....However i cant seem to find a...

HI I have a '94 2.4d. Driving along today no problems with gear changes or clutch slipping, until i stopped at a junction and then i was not able to select any gear. I can select all gears with the engine turned off. But when engine is on nothing. Its like i haven't pressed the clutch down...

Ok so this is my second attempt at posting this, my first attempt disappearing into the ether. I have two friends who have had T5's. 2.5's . Both have bent a con rod Is this a common issue ? With commonly known causes ??. I'm buying my friends off him. it's a 2006 2.5 174BHp with a bent con rod...

I replaced my front discs and pads today, another item ticked off the massive MOT fail sheet! I took the old boat for a run to check they were ok (first time i've fitted brakes) and alls well! (Learning a lot with this bloody van) Anyway, next problem decides to rear its ugly head, there is some...

Found this whist trawling for T5 5 cyl engine information http://pierro777.free.fr/DOCVAG/2.5_TDI.pdf

Having read various differing views on gas safety and requirements I thought I would ask the experts. An article in MMM Motorhome Monthly Magazine a few months ago provided the contact list and this is what I sent on the 19th March: It was sent to these people : [email protected]

Did a bit of a service ready for hols - including checking out brakes and bleeding them. Found the black rubber nipple thingy on top of master cylinder reservoir has a lump missing from it. Just behind the yellow filler cap in pic below. Looks like some kind of little plunger thing under it. The...