fault code

Ok not a T5 but a VW amarok but need to pick your brains please.Keep getting fault code P261a coming up,the coil light flashes and it goes into limp mode.Turn off for 5 mins and it resets and goes back to normal. I put it in local garage and they replaced secondary water pump with genuine vw...

Hi, can anyone help please? Blower has stopped working in the front and windscreen, although it still works in the back of the van. Air still comes out warm when the engine is hot. I called the RAC and it came up fault code B10A001 front fresh air blower electrical fault. Also B10AF04 air...

The engine management warning light has come on on my dashboard, got my mechanic to plug it into the diagnostic tool and it's come up with the error air intake temperature sensor high. Thought this was just faulty sensor and replaced the mass intake air sensor attached to the airbox, cleared the...

Hi all, I found this forum whilst searching for my problem online, but can't find quite the answer I'm looking for.. My partner and I bought a VW T5 1.9 this weekend and since we returned home the glow plug light has been flashing and the van has been having difficulty starting. Over the last...

***Exhaust pressure sensor fault fixed*** This may save you £80+ for a new Exhaust pressure sensor should your engine light come on with this fault code. Mine kept coming on and in due course I switched it off via my code reader only to have it come back on a few days later. So, with nothing to...

Hi folk, I have just had a look at my 2.5 AJT with VCDS lite mainly because the van is smoking loads. I got thee following results: Group 004 775rpm 1.8 BTDC Requested 1.8-3.3 BTDC Actual 14.7% Duty Cycle I have no idea what this means!! Also there is the following fault code: 18009 -...

...ECU testing couldn't repair my control unit so I had to buy a new one from VW. Just fitted it and pleased to say the the speedo etc all works again. Still have some flashing lights though - do you think I just need to reset the fault codes? Anyone know anywhere that would do it in Glasgow...

Can anyone help with this? There are no wiring diagrams for it that I can find. Dont even know where it is located to take a look and clean etc. Any help really appreciated, or any recommendations of who I could take it to in the Bristol/Weston Super Mare area that may be able to work on it...