Hi Thinking of ordering H&R 40mm lowering springs or Vogtland 50mm lowering springs (can't decide) to fit to my T30 SWB panel van 61 reg sat on 18" Rivas. I will be fitting new rear spring cups with the new springs, but is replacing the top front mounts necessary with this milage on? Any...

Managed to round the screws for the engine coil while trying to remove it, had to drill one screw out but the other one was impossible to reach. That along with rust under the mounting bracket...lets just say that I need a new bracket to fit my new engine coil I: Any of you know if its possible...

Hi, I know there have been threads on this before but they seemed to have dried up. Does any one know of or can recommend a TV mount and/or bracket that I can use to mount a 16inch LCD onto the B pillar of my T5? Preferably I want one where the VESA mount can be detached from the arm so I can...

Hi I've just replaced the 2 mid sections of the exhaust on the van (new mounts too) all good but noticed on the start of the back box section I.E before the silencer close to joint with next section. That there is a hook mount the same as the one on the previous section used to mount the rubber...

I need a bracket for the lower engine mount but the part no. and description Vw gave me yesterday when I search comes up with something that doesnt look like the part I need, and I need to get it fitted asap?? The actual part itself is the bracket that the lower engine mount bolts on to does...

for a while now I've been wanting to mount a tablet in the dash. unfortunately the tablet i had was old and laggy so I didn't want to waste my time on something that doesn't even do what i want it to. I recently purchased the Google Nexus 7 3G and WiFi so my plan started all over again. As i...

Like many I have the mount in my wind screen for a mirror, but no mirror, just a little black dome, searching the forum I found it could be removed and a mirror put in it's place, I also found some horror stories about people cracking their windscreens by pushing too hard on the dome. I give...

I need to remove the power steering mount on my 1.9 TD ABL engine to gain access to the bolts that secure the sump. It looks like the power steering pump mount is held on the engine block with 2 cap head (6mm hex) bolts however I cannot get anything on one of them to turn it! the drive shaft...