VW T4 Forum - VW T5 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
812 Posts
Discussion Starter #1
Hi all,

Had a few problems with my T4 1.9 TDI conversion, Iv sorted the air in the fuel pipes problems and finally got it on a scanner today.

I'm getting needle lift sensor (G80) input open. I'm going to get the multimeter out tomorrow and test it, probly a wiring fault as I had uprated injectors off rake 3-4 years ago.

Can anyone give me some insite into the problem reading the Internet it seems quite common?

Cheers Mike
 

·
07415125940
Joined
·
6,662 Posts
Hi Mike

Eliminate the injector first by measuring the resistance across the connector in the injector side.
Pin to pin should read 90-120 ohms at full temp.

If it reads good then check wiring.
 

·
Registered
Joined
·
812 Posts
Discussion Starter #3
Iv found the wire split at the top of the number 3 injector too close to solder.

Anyone know if the wiring part can be bought or am I looking an a new-second hand injector?

Cheers Mike
 
1 - 3 of 3 Posts
Top