[foxyloxey]

Hello
I have a 2010 T5.1 and got the ABS and TC yellow warning lights up on our holiday down in Cornwall, sometimes go off but mainly on.
I'm home and plugged it in to VCDS, showing fault on rear right sensor, no reading at all when rotating. Not had chance to delve deeper yet but doing my research on here and reading a lot about the wiring corrosion, but then read this is with earlier (pre 2009) T5's is this the case?
Next is, if I test the wire to sensor what voltage should I expect to see?
Any help appreciated on this and I know it's been covered before but the more I read the further I get from where to start.
Where do i start?

cheers

 

[teerak2uk]

Wiring is more a pre gp thing so could just be a bad sensor

 

[teerak2uk]

Voltage etc just compre with a working side

 

[foxyloxey]

thanks for that. I'll have a look at voltages when it/if it stops raining!

 

[foxyloxey]

Update for other with the same problem.

Changed the sensor (£36 for a Bosch) problem solved.

Sensor was a good fit so make sure you give the hole a really good clean.

Old sensor can be knocked out upwards with a pin punch.

Volts on terminals was 11.17. T: