VW T4 Forum - VW T5 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
97 Posts
look into the hole in the bell housing from the front of the van, when seen from above you can see the gear teeth on the left and then the bare metal of the edge of the wheel on the right. the cut out in the wheel you are looking for is to the left of the gear teeth hidden by the edge of the hole. so you have to get down to the right of the cylinder head and look back left to see it

There is no mark on the crank pulley end, but once aligned, I made some so that I wouldn't have to keep getting up from under the van when doing the cambelt setting
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top