VW T4 Forum - VW T5 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi Guys

I have a replacement tuned ECU to fit in my van, T4 1998 2.5 TDI 102 bhp.
I know its not rocket science but cannot figure out how to get the wiring loom / connector block off the top. Plus then not sure if I simply unscrew the 2 screws at the top from the mounting plate and then after disconnecting vacuum pipe just pull upwards and out ?.
I have read about sliding the top forward and left and right but don't see it ....
Attached is a picture of the block connector.
Thanks for your help really don't want to pay a garage to do this
P1000158.JPG
 
1 - 1 of 1 Posts
Top