VW T4 Forum - VW T5 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
416 Posts
Discussion Starter #1
Can anyone throw some light on this?

I've studied T4Trick's tech post on this and then my engine and It doesn't look the same. Probably a 2.5/1.9 variation.

I have a copper pipe which feeds into a kinda manifold but it looks very different and there is also no square inlet onto the head.

Am I being a dumbass?:confused:
 

·
Registered
Joined
·
329 Posts
Check out this thread...

http://www.vwt4forum.co.uk/showthread.php?t=36016

all you need I think...

ps I did mine, and it was a bit of a bugg3r to get the hex bolts off, but if you take the bottom ones off its easier to get access to the top ones you need to blank.
worth sealing the gaskets tho with instant gasket etc.. as mine was blowing from there when I first did it back up.
Just sealed it up today :)
 

·
Registered
Joined
·
416 Posts
Discussion Starter #3
Thanks Carbonmanx! That's the post I need but couldn't find! Won't have gaskets I don't think so hopefully it will hold tight.:ILU:
 
1 - 3 of 3 Posts
Top