VW T4 Forum - VW T5 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
would i need special bolts for fitting a rock n roll bed to my t4?do i need more than just a nut and bolt?thanks,Adrian
 

·
Registered
Joined
·
1,700 Posts
You will really need spreader plates as well. 2mm thick about 100 mm square with 10mm hole through the middle. Use M10 bolts about 75-80 mm should do and lock nuts. T:
 

·
Premium Member
Joined
·
3,304 Posts
If your rock n roll bed doesnt have any seat belts attached to it, then a couple of bolts will be good enough to hold down the frame. If its built to take the pull of a seat belt, then at least half a dozen 10mm bolts through spreader plates and chassis rails would be a good idea.

To give you an idea, this is how we tend to fit ours:



This particular photo is a T5, but you can see the brackets.
 
1 - 3 of 3 Posts
Top