VW T4 Forum - VW T5 Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
I know this has been covered a bit on here! but cannot seem to find any clear indication of what to do! In the process of taking gearbox out have dropped sub frame fully on pass side and loosened on drivers side and pushed bell housing away from main block. seem to not have enough clearance to free bell housing getting stuck on subframe and half shaft?! does the ball joint on the drivers side need to be undone to allow clearance if so which one steering rack or the other one? and have I lowered the engine and bell housing to low?

Cheers
 
1 - 1 of 1 Posts
Top