VW T4 Forum - VW T5 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
So people of T4's

I have blanked my EGR yesterday and cleaned my inlet out, messy job !!! However I have removed 2 nuts two get the inlet off and also two too get the EGR off the top end of the inlet. However should these nuts be tightened up to a specific talk (probably spelt wrong but in other words how tight should my nuts be in newtons?)

Cheers everyone

VW T4 1999 1.9TD

Jonty
 

·
Registered
Joined
·
1,685 Posts
No published torque setting that I can find ????
Just nipped up tight will do.......you'll soon know if they're not tight enough as it will blow exhaust gas out.
 

·
Registered
Joined
·
682 Posts
15 lb/ft or 20Nm seems to be used all over the engine for any thing being attached to the head in particular. Tensioners flanges and the likes. I think all the sump bolts are the same.
 
1 - 6 of 6 Posts
Top