VW T4 Forum - VW T5 Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
104 Posts
Discussion Starter · #1 ·
I have ave a set of 16" steels, little bit of surface rust etc that i want to get powder coated and fit some winter tyres too...

Looking for probably a satin light/mid grey finish

So does anyone have any recommendations....

Ta
 

·
Registered
Joined
·
452 Posts
These guys are located in Digbeth Birmingham if that's any help they did a fine job on mine. Stripped, dipped, marks linished out then coated in whatever colour I wanted for £20 a corner. Best £80 I've spent ever!!:ILU:

http://www.citypowdercoating.co.uk/
That's an absolutely awesome deal, shame Birmingham is 150 miles away from me!! :( I've got a set of 16" Audi alloys just waiting for a refurb before going onto my van!!
 

·
Registered
Joined
·
759 Posts
When you say north west where about are you located, mean place near me by chester does full refurbs and coats ?
 

·
Registered
Joined
·
104 Posts
Discussion Starter · #5 ·
Well Crewe for the next month but prepared to travel.

How much does the place Chester way charge?
 

·
Registered
Joined
·
170 Posts
look up alloytech their winsford based so only 7 miles away from crewe. My mate told me they did his and it was a really good job and they picked his car up from home fully insured to do so.
 

·
Registered
Joined
·
827 Posts
These guys are located in Digbeth Birmingham if that's any help they did a fine job on mine. Stripped, dipped, marks linished out then coated in whatever colour I wanted for £20 a corner. Best £80 I've spent ever!!:ILU:

http://www.citypowdercoating.co.uk/
ive used city loads in the past,very good job for what you pay,not that far from crewe,drop them off on way up and collect on way backT:
 
1 - 11 of 11 Posts
Top