VW T4 Forum - VW T5 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
364 Posts
Discussion Starter · #1 ·
Hi,

I am in the middle of replacing both rear quarters on my van. The arches weren't that bad but i had put a bit of filler in them 12 months ago but it was starting to bubble so decided to bite the bullet and replace the complete lower rear quarter. My problem is that where the rear panel joins the middle panel (drivers side) i won't be able to spot weld (mig) the new panel to the existing panel due to the center vertical bracing on the interior of the van, would it be ok to use something like tiger seal down the seam? would it be structurally sound or do you guys have any advice on welding the panel

I will try to upload a few pics when i find out how to post pics


cheers Alan
 
1 - 3 of 3 Posts
Top