VW T4 Forum - VW T5 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Can someone tell me the size of bolts required to fix the RNR to the lashing points they are the middle and rear two in my swb 2002 T4 please.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
That was what i was originally told and one fits that the one by the sliding door front of wheel arch, the other 3 seem a lot bigger my mate tried a 12mm no joy again to small, was told today that it might be seat belt size bolt, that was the reason for asking if any one knew, not a mechanic so new to this,
 

·
Registered
Joined
·
9,434 Posts
Standard load lashing point bolts are definitely M10. :*
 

·
Registered
Joined
·
180 Posts
That was what i was originally told and one fits that the one by the sliding door front of wheel arch, the other 3 seem a lot bigger my mate tried a 12mm no joy again to small, was told today that it might be seat belt size bolt, that was the reason for asking if any one knew, not a mechanic so new to this,
You might find that the plates with the captive nuts have come away. I had that with one of mine. The hole in the floor is bigger than M10, but the captive nuts are M10. Get under the van and have a look T:
 
1 - 6 of 6 Posts
Top