Hi am in the process of removing the VC from my 97 LWB 2.4 for a service. Have removed the prop shaft running from VC to the centre bearing.
The uni joint beside the centre bearing is quite stiff. I was wondering if you can take the end of it to clean it out & whack some new grease in it.
This is the one that has the rubber boot on it.
Have been thru All the syncro posts & U tube clips and don't seem to have anything on it.
Cheers.
![192004]( "192004")
The uni joint beside the centre bearing is quite stiff. I was wondering if you can take the end of it to clean it out & whack some new grease in it.
This is the one that has the rubber boot on it.
Have been thru All the syncro posts & U tube clips and don't seem to have anything on it.
Cheers.
