Mercedes alloy fitting problem

phantomratuk · Mar 7, 2011

Hi can anybody help i have some mercedes 7j 15 h2 pcd 112 alloys .. i went to fit them today and my stud will not go though the holes on them . the bolt is 3.7 and the hole is 2.7 so nearly a ml to big for the hole .... do i drill them ???
???????
and on the mecedes badge in the middle the hole is bigger than the centre lip ...

Flash000 · Mar 7, 2011

I had the same mate. I ended up drilling them and that worked great, just ordered some good quality drill bits for the job. Plus you will need spigot rings for the centre hole. Have a search on ebay and there;s plenty on there cheap as chips!

:ILU:

phantomratuk · Mar 7, 2011

Flash
Thats a massive help and thanks.T:
. do you no what spigot ring i would have to get?? or how i messure them ?? thanks again

Flash000 · Mar 7, 2011

Vw T4 Spigot rings for Mercedes wheels 66.6-57.1 should do the trick, maybe just measure yours to double check. But thats what I put on my 17' AMG alloys.

Drill out the holes from 12mm to 14mm. Take it nice and slowly with an electric drill rather than a cordless. Loads of info on here if you have a search around. T:

colese · Mar 7, 2011

as above spigot size is correct for merc rims...

14mm drill bit and just drill im out,very common to do mate..

Good luck and get them on..

phantomratuk · Mar 7, 2011

massive thanks flash and colese T:
lets hope i can get them on soon ... will post pics soon as its done :ILU:

Mercedes alloy fitting problem

Our Vendors

Top Contributors this Month

Recommended Communities